8
•
Duration of washing programme
in hours and
minutes, after you have selected a programme.
While the programme is running (after you have
pressed the “Start/Pause” button), the displayed time
value decreases by one unit every minute.
•
Selected drying time
in minutes or hours and
minutes (max 130 mins). .
After the programme has started the time remaining is
updated every minute.
•
The washing machine has stopped with water in
the tub
, at the end of a programme with the “
Rinse
Hold
” option: this is indicated by a
blinking zero
.
•
The washing machine has completed the
programme
: this is indicated by a
blinking zero
.
The zero will reappear when you switch the washing
machine on, unless the previous programme has been
erased by means of the Skip/Reset button.
0
1.25
2.05
Important!
The first time you use the machine
, when you switch
it on, it may display a blinking zero. This is due to the
fact that the machine has performed a washing cycle
during the manufacturer’s inspection tests, and this cycle
has not been erased after its completion.
•
Delay start
, a time value indicated in hours and selected
by means of the relevant button (max 23 hours).
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the “
Start/Pause
” button, the
delay time value displayed will decrease by units of
one hour every hour. When only two hours remain,
the display will decrease in 30 minute steps down to
zero.
You can delay the start of the selected programme by
up to 23 hours in one hour intervals.
•
An incorrect option selection has been made
: this is
indicated by the message
Err
when a function
incompatible with the current programme is selected.
•
An alarm code
indicates a fault in the machine
operation (see the relevant chapter on page 22-23).
E20
