Zanussi ZWD 81463 W, User Manual

To drain the water:
1. If necessary, decrease the spin speed. If you

set  , the appliance only drains.

2. Press 

. The appliance drains the water and

spins.

3. When the programme is completed and the

door lock indicator 

 goes off, you can open

the door.

4. Turn the programme knob to position   to

deactivate the appliance.

The appliance drains and spins

automatically after approximately 18

hours (except for Wool programme).

STAND-BY
Some minutes after the end of the washing

programme, if you do not deactivate the appliance,

the energy saving status activates.

The energy saving status decreases the energy

consumption when the appliance is on the stand

by.
• All indicators and the display go off.
• The indicator of the 

 flashes slowly

• Press one of the options to deactivate the

energy saving status.

If you set a programme or an option

that ends with water in the drum, the

energy saving status function doesn't

activate to remind you to drain the

water.

DAILY USE - DRYING ONLY

WARNING! Refer to Safety chapters.

DRYING SETTING

WARNING! Make sure that the

water tap is open.

1. Turn the programme knob to   to activate the

appliance.

2. Load the laundry one item at a time.

3. Turn the programme dial to the programme

applicable for the items to dry. The display

shows the drying indicator 

.

To have a good drying performance 

do not exceed the maximum drying

loads recommended in the user

manual. Do not set a spin speed

lower than the automatic speed of the

set programme.

DRYING AT AUTOMATIC LEVELS
The laundry can be dried at pre-defined levels of

dryness:
1. Press   again and again until the display

shows one of the dryness level indicator:

•

: IRON DRY level indicator for cotton

items

•

: CUPBOARD DRY level indicator for

cotton and synthetic items

•

: EXTRA DRY level indicator for cotton

items

The display shows a time value, calculated on the

default load size. If the amount of your laundry is

more or less than the default size, the appliance

adjusts automatically the time value during the

cycle.
2. Press 

 to start the programme.

The display shows the door locked indicator 

.

The drying indicator   starts to flash.

You cannot set all dryness levels for

any type of laundry.

TIMED DRYING
The laundry can also be dried with a manual timed

drying:
1. Press 

 again and again to set the time value

(see the «Programmes for timed drying» table).

• The display shows 10 minutes. Each time

you press this touchpad the time value

increases by 5 minutes.

• The display shows the set time value: for

example – 

 .

• After some seconds the display shows a

new time value: 

. The appliance

16