Zanussi ZWG 3105, User Manual

• Turn off the water tap.
• Unscrew the hose from

the tap.

• Clean the filter in the

hose with a stiff brush.

• Screw the hose back onto the tap. Make sure the

connection is tight.

• Unscrew the hose from the machine. Keep a rug

nearby because some water may flow.

• Clean the filter in the valve with a stiff brush or with

the piece of cloth.

35°

45°

• Screw the hose back to the machine and make sure

the connection is tight.

• Turn on the water tap.

Frost precaution

If the machine is exposed to temperatures below 0°C,

certain precautions should be taken.

• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency emptying hose and that

of the inlet hose in a bowl placed on the floor and let

water drain out.

• Screw the water inlet hose back on and reposition the

emergency emptying hose after having put the cap on

again.

• When you intend to start the machine up again, make

sure that the room temperature is above 0°C.

Emergency emptying out

If the water is not discharged, proceed as follows to empty

out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• open the pump door;
• place a bowl on the floor and place the end of the

emergency emptying hose into the bowl. Remove its

cap. The water should drain by gravity into the bowl.

When the bowl is full, put the cap back on the hose.

Empty the bowl. Repeat the procedure until water stops

flowing out;

• clean the pump if necessary as previously described;
• replace the emergency emptying hose in its seat after

having plugged it;

• screw the pump cover again and close the door.
Important!  Every time you drain the water through the

emergency emptying hose you must pour 2 litres of water

into the main wash compartment of the detergent drawer

and then run the drain programme. This will activate the

ECO Valve device avoiding that part of the detergent

remains unused at next washing.

Installation

Unpacking

All transit bolts and packing must be removed before us-

ing the appliance.

You are advised to keep all transit devices so that they

can be refitted if the machine ever has to be transported

again.

18