Zanussi ZWG 3105, User Manual

After removing all the

packaging, carefully lay

machine on it's back to re-

move the polystyrene base

from the bottom.

Remove the power supply

cable and the hoses from

the hose holders on the

rear of the appliance.

Unscrew the three bolts.

Slide out the relevant plas-

tic spacers.

Open the porthole and re-

move the polystyrene

block fitted on the door

seal.

Fill the smaller upper hole

and the two large ones

with the corresponding

plastic plug caps supplied

in the bag containing the

instruction booklet.

Positioning

Install the machine on a flat hard floor. Make sure that air

circulation around the machine is not impeded by carpets,

rugs etc. Check that the machine does not touch the wall

or other kitchen units. Level the washing machine by

raising or lowering the feet. The feet may be tight to adjust

as they incorporate a self locking nut, but the machine

MUST be level and stable.

Any necessary adjustment can be made with a spanner.

Accurate levelling prevents vibration, noise and displace-

ment of the machine during operation. Never place card-

board, wood or similar materials under the machine to

compensate for any unevenness in the floor.

If necessary, check the

setting with a spirit level.

Water inlet

Warning!  This appliance must be connected to a

cold water supply
Caution!  Before connecting up the appliance to new

pipework or to pipework that has not been used for

some time, run off a reasonable amount of water to flush

out any debris that may have collected

Caution!  Do not use the hose from your previous

appliance to connect to water supply.

Connect the hose to a tap

with a 3/4” thread. Always

use the hose supplied with

the appliance.

35°

45°

19