Zanussi ZWG 3105, User Manual

The other end of the inlet hose which connects to the

appliance can be turned as showed in the picture.

Do not place the inlet hose downwards. Angle the hose

to the left or right depending on the position of your

water tap. Set the hose correctly by loosening the ring

nut. After positioning the inlet hose, be sure to tighten

the ring nut again to prevent leaks.

Caution!  The inlet hose must not be lengthened. If

it is too short and you do not wish to move the tap,

you will have to purchase a new, longer hose specially

designed for this type of use.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a

sink using the plastic hose

guide supplied with the

machine.

In this case, make sure the end cannot come unhooked

when the machine is emptying. This could be done by

tying it to the tap with a piece of string or attaching it

to the wall.

In a sink drain pipe branch . This branch must be above

the trap so that the bend is at least 60 cm above the

ground.

Directly into a drain pipe at a height of not less than 60

cm and not more than 90 cm. The end of the drain hose

must always be ventilated , i.e. the inside diameter of

the drain pipe must be larger than the outside diameter

of the drain hose. The drain hose must not be kinked.

Electrical connection

Information on the electrical connection is given on the

rating plate on the inner edge of the appliance door.

Check that your domestic electrical installation can take

the maximum load required, also taking into account any

other appliances in use.

Caution!  Connect the machine to an earthed socket.
Caution!  The manufacturer does not accept any

responsibility for damage or injury through failure

to comply with the above safety precaution.

Caution!  The power supply cable must be easily

accessible after installing the machine.
Caution!  Should the appliance power supply cable

need to be replaced, this must be carried out by a

Service Centre.

Environment concerns

The symbol     on the product or on its packaging

indicates that this product may not be treated as

household waste. Instead it should be taken to the

appropriate collection point for the recycling of electrical

and electronic equipment. By ensuring this product is

disposed of correctly, you will help prevent potential

negative consequences for the environment and human

health, which could otherwise be caused by inappropriate

waste handling of this product. For more detailed

information about recycling of this product, please

contact your local council, your household waste disposal

service or the shop where you purchased the product.

Packaging materials

The materials marked with the symbol   are recyclable.

20