Zanussi ZWG 3105, User Manual

Daily use

Load the laundry

Open the door by carefully

pulling the door handle

outwards. Place the laun-

dry in the drum, one item

at a time, shaking them out

as much as possible.

Close the door.

Measure out the detergent and the fabric softener

Pull out the dispenser drawer until it stops. Measure

out the amount of detergent required, pour it into the
main wash compartment   or in the appropriate com-

partment if the selected programme/option it requires

(see more details in "Detergent dispenser drawer").

If required, pour fabric softener into the compartment
marked   (the amount used must not exceed the

«MAX» mark in the drawer). Close the drawer gently.

Select the required programme by turning the

programme selector dial (1)

Turn the programme selector dial to the required pro-

gramme. The washing machine will automatically select

the maximum spin value provided for the programme you

have chosen. You can change this value by pressing the

corresponding button. The green pilot light of the button

6 starts to flash.

The selector dial can be turned either clockwise or coun-

terclockwise. Turn to position « O » to reset programme/

Switching the machine off.

At the end of the programme the selector dial must be

turned to position O, to switch the machine off.

Caution!  If you turn the programme selector dial to

another programme when the machine is working,

the red  pilot light of button 6 will blink 3 times to indicate

a wrong selection. The machine will not perform the new

selected programme.

Select the required temperature by turning the

temperature selector dial (2)

Turn clockwise this dial to select the more convenient to

your laundry washing temperature.

Select the available options by pressing buttons 3,

4 and 5

Depending on the programme, different functions can be

combined. These must be selected after choosing the de-

sired programme and before starting the programme.

When these buttons are pressed, the corresponding pilot

lights illuminate. When they are pressed again, the pilot

lights go out. If an incorrect option is selected, the inte-

grated red pilot light of the button 6 flashes for 3 times.

For the compatibility among the washing pro-

grammes and the options see chapter «Washing

Programmes».

Start the programme by pressing button 6

To start the selected programme, press the button 6 , the

corresponding green pilot light stops blinking. The ap-

pliance starts operating and the only pilot light corre-

sponding to the running phase stays on.

To interrupt a programme which is running, press the

button 6 : the corresponding green pilot light starts blink-

ing.

To restart the programme from the point at which it was

interrupted, press the button 6 again .

If an incorrect option is selected, the red pilot light of the

button 6 blinks 3 times.

Altering an option or a running programme

It is possible to change some options before the pro-

gramme carries them out.

Before you make any change, you must PAUSE the ap-

pliance by pressing the button 6 .

Changing a running programme is possible only by re-

setting it. Turn the programme selector dial to O and then

to the new programme position. Start the new programme

by pressing the button 6 again. The washing water in the

tub will be not emptied out.

7