Zanussi ZWG 3105, User Manual

Interrupting a programme

Press the button 6 to interrupt a programme which is

running, the corresponding green pilot light starts blink-

ing.

Press the button again to restart the programme.

Cancelling a programme

Turn the selector dial to   to cancel a programme which

is running. Now you can select a new programme.

Opening the door

After the programme has started the door is locked. If, for

any reason, you need to open it, set firstly the machine to

PAUSE by pressing the button 6 . After a few minutes it

will be possible to open the door.

If the door remains locked, this means that the machine

is already heating or that the water level is too high. In

any case, do not try to force the door!

If you cannot open the door but you need to open it you

have to switch the machine off by turning the selector dial

to O . After a few minutes the door can be opened (pay

attention to the water level and temperature!) .

After closing the door, it is necessary to select the pro-

gramme and options again and to press button 6 .

At the end of the programme

The machine stops automatically. The pilot light of button

6 and the pilot light corresponding to the just finished

washing phase go off. The light 7.3 illuminates.

If a programme or an option that ends with water left in

the tub has been selected, the light 7.3 illuminates but the

door remains locked to indicate that the water must be

emptied out before opening the door.

Follow the below instructions to empty out the water:
1. Turn the programme selector dial to O .
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the

relevant button.

4. Press button 6 .

At the end of the programme, the door can be now opened.

Turn the programme selector dial to O to switch the ma-

chine off.

Remove the laundry from the drum and carefully check

that the drum is empty. If you do not intend to carry out

another wash, close the water tap. Leave the door open to

prevent the formation of mildew and unpleasant smells.

Helpful hints and tips

Sorting out the laundry

Follow the wash code symbols on each garment label and

the manufacturer’s washing instructions. Sort the laundry

as follows: whites, coloureds, synthetics, delicates, wool-

lens.

Before loading the laundry

Never wash whites and coloureds together. Whites may

lose their «whiteness» in the wash.

New coloured items may run in the first wash; they should

therefore be washed separately the first time.

Button up pillowcases, close zip fasteners, hooks and

poppers. Tie any belts or long tapes.

Remove persistent stains before washing.

Rub particularly soiled areas with a special detergent or

detergent paste.

Treat curtains with special care. Remove hooks or tie them

up in a bag or net.

Removing stains

Stubborn stains may not be removed by just water and

detergent. It is therefore advisable to treat them prior to

washing.

Blood: treat fresh stains with cold water. For dried stains,

soak overnight in water with a special detergent then rub

in the soap and water.

Oil based paint: moisten with benzine stain remover, lay

the garment on a soft cloth and dab the stain; treat several

times.

Dried grease stains: moisten with turpentine, lay the gar-

ment on a soft surface and dab the stain with the fingertips

and a cotton cloth.

Rust: oxalic acid dissolved in hot water or a rust removing

product used cold. Be careful with rust stains which are

not recent since the cellulose structure will already have

been damaged and the fabric tends to hole.

Mould stains: treat with bleach, rinse well (whites and fast

coloureds only).

Grass: soap lightly and treat with bleach (whites and fast

coloureds only).

8