Problem
Possible solution
The spin phase does
not operate
or
the washing cycle lasts
longer than usually.
Adjust manually the items in the drum and start the spin phase again. This problem
may be caused by balance problems.
Set the spin programme.
Set the drain programme if you set an option which ends with water in the drum.
If above mentioned solutions do not help, contact the Service (as the filter of the
drain pump may be clogged).
There is water on the
floor.
Make sure that the couplings of the water hoses are tight and there are no water
leakages.
Make sure that the water inlet hose and the water drain hose has no damages.
Make sure you use the correct detergent and the correct quantity of it.
You cannot open the
appliance door.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
The appliance makes an
unusual noise.
Make sure that the leveling of the appliance is correct. Refer to 'Installation in-
struction'.
Make sure that the packaging and/or the transit bolts are removed. Refer to 'Instal-
lation instruction'.
Add more laundry in the drum. The load may be too small.
The appliance fills with
water and drain immedi-
ately.
Make sure that the drain hose is in the correct position. The end of the hose may
be is too low. Refer to 'Installation instruction'.
The washing results are
not satisfactory.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
After the check, activate the appliance. The
programme continues from the point of inter-
ruption.
If the problem occurs again, contact the Serv-
ice.
If the display shows other alarm codes, activate
and deactivate the appliance. If the problem
continues, contact the Service.
Service
We recommend the use of original spare parts.
When contacting the Service, make sure that
these data are available. You can find the infor-
mation on the rating plate: model (Mod.), PNC
(Prod.No.), Serial number (Ser.No.).
Technical information
Dimensions
Width / Height / Depth
595 / 850 / 450 mm
Total depth
490 mm
16
www.zanussi.com
Summary of Contents for ZWG 7102 V
Page 1: ...EN User manual Washing Machine ZWG 7102 V ...
Page 18: ...18 www zanussi com ...
Page 19: ...19 www zanussi com ...
