Zanussi ZWH 6125, User Manual

1. Turn the programme selector dial to   .
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the

relevant button.

4. Press button 7 .

At the end of the programme, the door is released and can
be opened. Turn the programme selector dial to   to

switch the machine off.

Remove the laundry from the drum and carefully check

that the drum is empty. If you do not intend to carry out

another wash, close the water tap. Leave the door open to

prevent the formation of mildew and unpleasant smells.

Stand By : If your laundry is not removed within 10 mi-

nutes after the programme is finished, the back light of

the display switches off and the energy saving system will

be enabled. Only the pilot light of the button 7 is blinking

to indicate that the appliance has to be switched off. By

pressing any button the appliance will come out from the

energy saving status and you can set another programme

or switch the appliance off.

Care and cleaning

Warning!  You must DISCONNECT the appliance

from the electricity supply, before you can carry out

any cleaning or maintenance work.

Descaling

The water we use normally contains lime. It is a good idea

to periodically use a water softening powder in the ma-

chine. Do this separately from any laundry washing, and

according to the softening powder manufacturer's in-

structions. This will help to prevent the formation of lime

deposits.

External cleaning

Clean the exterior cabinet of the appliance with soap and

water only, and then dry thoroughly.

Cleaning the drawer recess

The washing powder and additive dispenser drawer

should be cleaned regularly.

Remove the drawer by

pressing the catch down-

wards and by pulling it

out. Flush it out under a

tap, to remove any traces

of accumulated powder.

To aid cleaning, the top

part of the additive com-

partment should be re-

moved.

Cleaning the drawer recess

Having removed the draw-

er, use a small brush to

clean the recess, ensuring

that all washing powder

residue is removed from

the upper and lower part of

the recess.

Replace the drawer and run the rinse programme with-

out any clothes in the drum.

Cleaning the pump

The pump should be inspected if:
• the machine does not empty and/or spin;
• the machine makes an unusual noise during draining

due to objects such as safety pins, coins etc. blocking

the pump.

Proceed as follows:
• disconnect the appliance;
• if necessary wait until the water has cooled down.

Open the pump door.

Place a container close to

the pump to collect any

spillage.

13