Zanussi ZWH 6125, User Manual

• When you intend to start the machine up again, make

sure that the room temperature is above 0°C.

Emergency emptying out

If the water is not discharged, proceed as follows to empty

out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• open the pump door;
• place a bowl on the floor and place the end of the

emergency emptying hose into the bowl. Remove its

cap. The water should drain by gravity into the bowl.

When the bowl is full, put the cap back on the hose.

Empty the bowl. Repeat the procedure until water stops

flowing out;

• clean the pump if necessary as previously described;
• replace the emergency emptying hose in its seat after

having plugged it;

• screw the pump cover again and close the door.
Important!  Every time you drain the water through the

emergency emptying hose you must pour 2 litres of water

into the main wash compartment of the detergent drawer

and then run the drain programme. This will activate the

ECO Valve device avoiding that part of the detergent

remains unused at next washing.

What to do if ...

Certain problems are due to lack of simple maintenance

or oversights, which can be solved easily without calling

out an engineer. Before contacting your local Service

Centre, please carry out the checks listed below.

During machine operation it is possible that the red pilot

light of button 7 blinks, one of the following alarm codes

appears on the display and some acoustic signals sound

every 20 seconds to indicate that the machine is not

working:

•

 : problem with the water supply.

•

 : problem with the water draining.

•

 : door open.

Once the problem has been eliminated, press the button

7 to restart the programme. If after all checks, the problem

persists, contact your local Service Centre.

Problem

Possible cause/Solution

The machine does not start:

The door has not been closed. 
• Close the door firmly.

The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.

There is no power at the socket.
• Please check your domestic electrical installation.

The main fuse has blown.
• Replace the fuse.

The selector dial is not correctly positioned and the button 7 has not been

pressed.
• Please turn the selector dial and press the button 7 again.

The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.

The Child Safety Lock has been activated.
• Deactivate the Child Safety Lock.

15