Problem
Possible solution
Set the drain or the spin programme if there is water in the drum.
The appliance makes an un-
usual noise.
Make sure the levelling of the appliance is correct. Refer to 'Installation'.
Make sure that the packaging and/or the transit bolts are removed. Refer to
'Installation'.
Add more laundry in the drum. The load may be too small.
The appliance fills with water
and drain immediately.
Make sure that the drain hose is in the correct position. The hose may be too
low.
The washing results are not
satisfactory.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash the
laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
After the check, activate the appliance. The pro-
gramme continues from the point of interruption.
If the problem occurs again, contact the Serv-
ice.
If the display shows other alarm codes. Deacti-
vate and activate the appliance. If the problem
continues, contact the Service.
Service
We recommend the use of original spare parts.
When contacting the Service, make sure that
these data are available. You can find the infor-
mation on the rating plate: model (Mod.), PNC
(Prod.No.), Serial number (Ser.No.).
Technical information
Dimensions
Width / Height / Depth
600 / 850 / 600 mm
Total depth
640 mm
Electrical connection:
Voltage
Overall power
Fuse
Frequency
220-230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles and moisture ensur-
ed by the protective cover, except where the low voltage equipment has
no protection against moisture
IPX4
Water supply pressure
Minimum
0,5 bar (0,05 MPa)
Maximum
8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum load
Cotton
7 kg
Spin speed
Maximum
1200 rpm
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
18
www.zanussi.com