Zanussi ZWM 150, Instruction Booklet

ENGLISH

19

Water inlet filter

If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose is not
blocked.

Turn off the water tap.

Unscrew the hose from the tap.

Clean the filter with a stiff brush.

Screw the hose back onto the tap.

Emergency emptying out

If the water is not discharged, proceed as follows to
empty out the machine:

• pull out the plug from the power socket; 

• close the water tap; 

• if necessary, wait until the water has cooled down;

• place a bowl on the floor;

• put the drain hose end into the bowl and let the

water come out.

Should it not be possible to have access to the drain
hose because, for example, the appliance is built in
the kitchen furniture, slightly loosen the drain filter
after placing a bowl on the floor, to let the water
come out slowly.

At the end screw the filter again.

P1090

Frost precautions

If the machine is installed in a place where the
temperature could drop below 0°C, proceed as
follows:

• Close the water tap and unscrew the water inlet

hose from the tap.

• Place the end of the drain hose and that of the inlet

hose in a bowl placed on the floor.

• Select programme 

and run it until the machine

stops.

• Remove the plug from the socket.

• Screw the water inlet hose back on and put the

drain hose back in its place.

By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.

When you use the machine again, make sure that
the ambient temperature is above 0°C.

132990240.qxd  20/02/2004  15:18  Pagina  19    (Nero/Process Black pellicola)