Start the programme by pressing button 7
To start the selected programme, press this
button; the corresponding green pilot light
stops blinking.
The pilot light
9
illuminates to indicate that the
appliance starts operating and the door is
locked.
If you have chosen a delayed start, the machine
will begin the countdown.
Important!
If an incorrect option is selected,
the message
Err
is displayed for a few seconds
and the
red
pilot light of this button blinks 3
times.
Select the Delay Start by pressing button
8
Before you start the programme, if you wish to
delay the start, press this button to select the
desired delay.
The selected delay time value will appear on the
display for a few seconds, then the duration of
the programme will appear again.
You must select this option after you have set
the programme and before you start the pro-
gramme.
You can cancel or modify the delay time at any
moment, before you press button
7
.
Selecting the delay start :
1.
Select the programme and the required op-
tions.
2.
Select the delay start by pressing button
8
.
3.
Press button
7
:
- the machine starts its hourly countdown.
- the programme will start after the selected
delay has expired.
Cancelling the Delay Start after having started
the programme:
1.
Set the washing machine to PAUSE by
pressing button
7
.
2.
Press button
8
once. On the display will
appear
'
.
3.
Press button
7
again to start the pro-
gramme.
Important!
• The selected delay can be changed only after
selecting the washing programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing button
7
and wait a few minutes be-
fore opening the door. After you have closed
the door, press the same button again.
Important!
The Delay Start
cannot
be
selected with the draining programme.
Altering an option or a running
programme
It is possible to change some options before the
programme carries them out.
Before you make any change, you must pause
the washing machine by pressing button
7
.
Changing a running programme is possible only
by resetting it. Turn the programme selector dial
to
and then to the new programme position.
Start the new programme by pressing button
7
again.
The washing water in the tub will be not emp-
tied out.
Interrupting a programme
Press the button
7
to interrupt a programme
which is running, the corresponding pilot light
starts blinking. Press the button again to
restart
the programme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running. Now you can select a
new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing the
button
7
.
If the pilot light
9
blinks and after a few minutes
goes off, the door can be opened.
If the pilot light
9
remains lit, this means that the
machine is already heating or that the water lev-
el is too high. In any case, do not try to force the
door open!
If you cannot open the door but you need to
open it, you have to switch the machine off by
turning the selector dial to
. After a few mi-
nutes the door can be opened.
(Pay attention to the water level and tem-
perature!).
11
www.zanussi.com
Summary of Contents for ZWN 7100 L
Page 1: ...EN User manual Washing Machine ZWN 7100 L ZWN 7120 L ...
Page 26: ...26 www zanussi com ...
Page 27: ...27 www zanussi com ...
