Zanussi ZWN 7100 L, User Manual

Display (10)

10.1

10.2

The display shows the following information:

10.1: Child safety lock

This device permits you to leave the appliance
unattended during it's functioning.

10.2:

•

Duration of the selected programme

After selecting a programme, the duration is
displayed in hours and minutes (for example

 ). The duration is calculated automati-

cally on the basis of the maximum recommen-
ded load for each type of fabric. After the
programme has started, the time remaining is
updated every minute.

•

Delayed start

The Selected delay set by pressing the rele-
vant button appears on the display for a few
seconds, then the duration of the selected
programme is displayed again. The delay time
value decreases by one unit every hour and
then, when 1 hour remains, every minute.

•

Alarm codes

In the event of operating problems, some
alarm codes can be displayed, for example

 (see paragraph «What to do if...»).

•

Incorrect option selection

If an option which is not compatible with the
set wash programme is selected, the mes-
sage 

Err

 is displayed at the bottom of the

display for a few seconds. The integrated red
light of button 

7

 starts flashing.

•

End of programme

When the programme has finished the flash-
ing zero (   ) is displayed. The pilot light 

9

and the pilot light of button 

7

 go out. The

door can be opened.

First use

• Ensure that the electrical and water con-

nections comply with the installation in-
structions.

• Remove the polystyrene block and any

material from the drum.

• Pour 2 litres of water into the main wash

compartment 

 of the detergent drawer

in order to activate the 

ECO

 valve. Then

run a cotton cycle at the highest temper-
ature without any laundry in the machine,
to remove any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main wash
compartment and start the machine.

Personalisation

Acoustic signals

The machine is provided with an acoustic de-
vice, which sounds in the following cases:

• at the end of the cycle

• if there is a fault.
By pressing the 

4

 and 

5

 buttons simultaneously

for about 

6 seconds

, the acoustic signal is de-

activated (except if there is a fault). By pressing
these 2 buttons again, the acoustic signal is re-
activated.

Child safety lock

This device permits you to leave the appliance
unattended so you do not need to worry that
children might be injured by or cause damage to
the appliance. This function remains enabled al-
so when the washing machine is not working.
There are two different ways to set this option:

1.

Before pressing button 

7

: it will be impossi-

ble to start the machine.

2.

After pressing button 

7

: it will be impossi-

ble to change any other programme or op-
tion.

8

www.zanussi.com