Zanussi ZWT10710W, User Manual

Problems without alarm messages

Description

Inspection Items

The appliance is not washing

If the power is off or the fuse is burned out.

If the power supply voltage is too low.

If the water amount reaches to the required water level.(The

washer will not work if the water amount does not reach the re-

quired water level)

If it is set to "Delay" washing mode. (It will only start to work until

the reservation time reached)

No water flows in

If the power is off or the fuse is burned out.

If the water supply is cut off or the water pressure is too low.

If the inlet hose is properly connected and the water tap is

opened.

If the filtering screen of inlet valve is blocked by dirt.

If the coil of inlet valve is damaged. (The slight electromagnetic

sound is normal phenomenon when the inlet valve is switched

on)

If the "Start / Pause" button is pressed after the power switch is

pressed.

Abnormal draining

If the water drain hose is placed very high.

If the end of water drain hose is sealed in pond.

If the internal rubber ring of drain valve is blocked by dirt.

Abnormal spin

If the door lid is not closed properly.

If all clothing piled largely at one side of barrel or the clothing is

excessively placed.

If the washer is not placed in stable condition or it is placed in

inclination state. (The ground is not flat).

If the motor belt is loosened.

If the problem occurs again, contact the Authorised Service Centre.

TECHNICAL DATA

Dimension

Height x Width x Depth

965mm x 550mm x 578mm

Electrical connection

Voltage

Overall power

Fuse

Frequency

220-240 V

510 W

10 A

50 Hz

Level of protection against ingress of solid particles and moisture

ensured by the protective cover, except where the low voltage

equipment has no protection against moisture.

IPX4

Water supply pressure

Minimum

Maximum

0.3 bar (0.03 MPa)

8 bar (0,8 MPa)

Water supply

1)

Cold water

Hot water

Maximum load

10 kg

14