Zanussi ZXAN9FW0, User Manual

CAUTION! If you install the appliance

next to a wall, refer to the installation

instructions to understand the

minimum distance between the wall

and the side of the appliance where

door hinges are to provide enough

space to open the door when the

internal equipment is removed (e.g.

when cleaning).

This appliance is intended to be used at ambient

temperature ranging from 16°C to 38°C.

The correct operation of the appliance

can only be guaranteed within the

specified temperature range.

If you have any doubts regarding

where to install the appliance, please

turn to the vendor, to our customer

service or to the nearest Authorised

Service Centre.

It must be possible to disconnect the

appliance from the mains power

supply. The plug must therefore be

easily accessible after installation.

ELECTRICAL CONNECTION
• Before plugging in, ensure that the voltage and

frequency shown on the rating plate correspond

to your domestic power supply.

• The appliance must be earthed. The power

supply cable plug is provided with a contact for

this purpose. If the domestic power supply

socket is not earthed, connect the appliance to

a separate earth in compliance with current

regulations, consulting a qualified electrician.

• The manufacturer declines all responsibility if

the above safety precautions are not observed.

• This appliance complies with the E.E.C.

Directives.

LEVELLING
When placing the appliance make sure that it

stands level. This can be achieved by two

adjustable feet at the bottom in front.

DOOR REVERSIBILITY

WARNING! Before carrying out any

operations, remove the plug from the

power socket.

1. Make sure the appliance stands upright.

2. Open the door and remove the door

equipment. Refer to the "Daily Use" chapter.

Close the door.

3. Unscrew the screws on the back of the top

cover.

4. Lift the top cover and place it on a soft surface.

5. Remove the decorative cover and put it in a

safe place.

6. Unscrew the 2 screws that connect the upper

hinge. Put the upper hinge in a safe place

together with the screws.

7. Lift the door and put it on a soft surface.

8. Tilt the appliance carefully on a soft foam

packaging or similar material to avoid any

damage to the back of the appliance and the

floor.

9. Remove the upper plug and transfer it to the

uncovered hole of the upper hinge on the other

side of the appliance. Press the plug firmly into

the hole.

10. Unscrew the screws of the bottom hinge and

adjustable feet. Transfer them to the other side

of the appliance.

7