Zanussi ZYAE82ER, User Manual

Problem

Possible cause

Solution

Food products are not wrapped

properly.

Wrap the food products better.

Temperature is set incorrectly.

Refer to "Control panel" chapter.

Appliance is fully loaded and is set

to the lowest temperature.

Set a higher temperature. Refer to

"Control panel" chapter.

Temperature set in the appliance is

too low and the ambient tempera‐

ture is too high.

Set a higher temperature. Refer to

"Control panel" chapter.

Water flows on the floor.

The melting water outlet is not con‐

nected to the evaporative tray below

the appliance.

Attach the melting water outlet to

the evaporative tray.

Temperature cannot be set.

The FastFreeze function is switched

on.

Switch off FastFreeze function man‐

ually, or wait until the function deac‐

tivates automatically to set the tem‐

perature. Refer to "FastFreeze func‐

tion" section.

The temperature in the appliance is

too low/too high.

The temperature is not set correctly. Set a higher/lower temperature.

The door is not closed correctly.

Refer to "Closing the door" section.

The food products' temperature is

too high.

Let the food products temperature

decrease to room temperature be‐

fore storage.

Many food products are stored at

the same time.

Store less food products at the

same time.

The thickness of the frost is greater

than 4-5 mm.

Defrost the appliance.

The door has been opened often.

Open the door only if necessary.

The FastFreeze function is switched

on.

Refer to "FastFreeze function" sec‐

tion.

There is no cold air circulation in the

appliance.

Make sure that there is cold air cir‐

culation in the appliance. Refer to

"Hints and tips" chapter.

Power indicator light flashes.

An error has occurred in measuring

the temperature.

Contact a qualified electrician or the

nearest Authorized Service Centre.

If the advice does not lead to the desired

result, call the nearest Authorized

Service Centre.

8.2 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

installation instructions.

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

14 ENGLISH