Zanussi ZYAE82ER, User Manual

3.2 Location

To ensure appliance's best functionality, you

should not install the appliance in a place with

direct sunlight. Do not install the appliance

close to radiators or cookers, ovens, or hobs,

unless otherwise specified in the installation

instructions.
Make sure that air can circulate freely around

the back of the cabinet.
This appliance should be installed in a dry,

well ventilated indoor position.
This appliance is intended to be used at

ambient temperature ranging from 10°C to

43°C.

The correct operation of the appliance

can only be guaranteed within the

specified temperature range.

If you have any doubts regarding where

to install the appliance, please turn to the

vendor, to our customer service or to the

nearest Authorised Service Centre.

It must be possible to disconnect the

appliance from the mains power supply.

The plug must therefore be easily

accessible after installation.

3.3 Electrical Connection

CAUTION!

Any electrical work required to install this

appliance should be carried out by a

qualified electrician or competent person.

WARNING!

This appliance must be earthed.

The manufacturer declines any liability

should these safety measures not be

observed.

The wires in the mains lead are coloured in

accordance with the following code:

A

B

C

D

E

• A - green and yellow: Earth

• C - brown: Live

• D - blue: Neutral

As the colours of the wires in the mains lead

of this appliance may not correspond with the

coloured markings identifying the terminals in

your plug, proceed as follows:

1. Connect the wire coloured green and

yellow to the terminal marked either with
the letter “E“ or by the earth symbol   or

coloured green and yellow.

2. Connect the wire coloured blue to the

terminal either marked with the letter

“N“ or coloured black.

3. Connect the wire coloured brown to the

terminal either marked with the “L“ or

coloured red.

4. Check that no cut, or stray strands of wire

is present and the cord clamp (E) is

secure over the outer sheath.

Make sure the electricity supply voltage is

the same as that indicated on the

appliance rating plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp fuse

(B). In the event of having to change the fuse

in the plug supplied, a 13 amp ASTA

approved (BS 1362) fuse must be used.

WARNING!

A cut off plug inserted into a 13 amp

socket is a serious safety (shock) hazard.

Ensure that it is disposed of safely.

ENGLISH 7