This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery and recycling please return to your local designated
WEE/CG0783SS collection point as defined by your local council.
© 2022 System Q Ltd
2
Surface Mount Mag Lock
Zap is a registered trademark of System Q Ltd
Document ref: qACC510
All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is
made to ensure that these instructions are complete and accurate, System Q Ltd cannot be held responsible for any losses, no matter how they arise,
from errors or omissions in these instructions, or the performance or non-performance of the equipment refered to.
the Mag Lock. This allows for installations where the exit button isn't
situated next to the door and a timed released is required.
Mounting
Troubleshooting
If the door release is not activating the lock then there is likely a shorted wire, open circuit or some other failed device in
the circuit.
To identify where the fault is, each wired connection in the circuit needs to be tested; working from the door release
progress through, including the power supply and the magnetic lock.
If the fault is with the door release then check the connection wires for continuity and for trapped wires. Check for water
ingress on the wired connections. Check the polarity in the power connections and ensure the connections are connected
to the proper terminals.
Specification
ACC510
Design
Surface Mount
Holding Force
280kg (600lbs)
Delay
Adjustable: 0~30s
Relay Output
NO / COM / NC
Voltage
12V DC / 430mA (Holding)
LED Colour
Red= Power on and pull in place
Green= Power on and lock opened
Construction
Metal
Dimensions
(H) 48 x (W) 250 x (D) 27mm (Lock)
