6
Setup Procedure
1.
Disable the SLN-4 by pushing the “ENABLE” button in.
2.
Adjust the music level such that it is barely audible above the
background noise.
3.
Put the SLN-4 in the 5kHz mode by putting the range switch
in the out position. (Recommended)
4.
Adjust the decay to .1 seconds. This is a temporary setting
so that you get a quick response to the threshold adjustment.
5.
Enable the SLN-4 by putting the “ENABLE” button in the out
position.
6.
Adjust the Threshold so that the “GATE ON” LED flickers on
and off.
7.
Adjust the decay to about 2 seconds.
Preliminary adjustments are now complete. Due to its smart
band limiting circuitry, these should be the only adjustments that
you need to make. If you have system noise that is in the lower
frequency range (you shouldn’t), you may have to put the range
switch in the full range position.
Note: Use the front channels of the SLN-4 if you are using only
two. While the SLN-4 gates all four channels, it only senses
music on the front channels.
Summary of Contents for SymbiLink SLN-4
Page 1: ......
Page 8: ...7 Switch and Control Settings...
Page 9: ...8 System Example 1...
Page 10: ...9 System Example 2...
