10.
Apply foam gasket tape to the internal perimeter of the cabinet, where the front
baffle will eventually rest. The purpose of this step is to ensure an airtight seal
between the baffle and cabinet. Some customers prefer to use their own alternate
sealer product, removable or permanent.
11.
Properly mount the MD14-B4 pre-cut baffle into the cabinet with the screws and
washers from step 2. The tweeter hole should look through to the port tube, the
woofer hole to input cup and crossover area. The baffle is now correctly installed.
12.
Apply foam gasket tape around the back flange of the tweeter and woofer. Also
apply foam gasket tape around the recessed area of the tweeter hole on the front
baffle – this is to ensure the tweeter will sit flush with the front baffle when
mounted.
13.
Pull the remaining wires through the appropriate cutout holes in the baffle. You
have marked the tweeter wire with a marker or tape in step 4. At this point, take a
look at how the internal wire has arranged itself inside the cabinet. A small
amount of left over Acousta-Stuf or some that is accessible in the cabinet may be
used to ensure the wire will not rest, rub or tap against any hard surfaces in the
cabinet.
14.
Carefully solder the leads to each driver. Observe polarity. (If you are questioning
your soldering skills, we have provided quick connects to make this step a little
easier. Once you crimp the quick connects on the stripped ends of the wire, press
them onto the appropriate tabs of each driver. We highly recommend that you
make this connection permanent by soldering the quick connects to the driver tabs
at this time.)
15.
Mount the drivers into the cabinets with the provided screws. We have provided
you with your choice of Phillips head or Socket head screws. Take note of how
you want the screw alignment to look, line up the driver accordingly in the baffle
recess and proceed. Note: Bring the screw head just short of contact with the
driver flange, and then tighten each screw slowly allowing the gasket to compress
and the driver to become flush with the baffle.
16.
Your ZA-SR71 kit is now complete.
17.
Plug, play and enjoy!
Detailed information on this kit is available at
www.madisound.com
and
www.zaphaudio.com
