Page 33
6.4 DESCRIPTION OF CONSOLE RESTORE FUNCTION.
The RESTORE PARAM function allows transfer of the Console’s stored data into the
memory of the chopper. This is achieved in a fast and easy way using the method
previously used with the SAVE PARAM. function.
The data that is available via the RESTORE PARAM. function is as follows :
- All Parameter Values (PARAMETER CHANGE).
- Options (SET OPTIONS)
- The level of the Battery (ADJUST BATTERY)
ATTENTION: When the RESTORE operation is made, all data in the chopper memory
will be writtten over and replace with data being restored.
Flow Chart showing how tto use the RESTORE function of the Digital Console.
1) Opening Zapi Display.
2) Press ENTER to go into the General menu.
3) The Display will show :
4) Press ROLL UP or ROLL DOWN button until
RESTORE PARAM. appears on the display.
5) The Display will show :
6) Press ENTER to go into the RESTORE PARAM. function.
7) The Display shows the type of Model stored,
with a Code Number.
8) Keep pressing either ROLL UP and ROLL DOWN buttons
until the desired model appears on the Display.
9) Press ENTER to commence the Restore operation.
10) The Display will ask “ARE YOU SURE”.
Press ENTER for YES, or OUT for No.
11) You can see the items that are being stored in
the chopper memory whilst the RESTORE
routine is happening.
12) When finished the Console displays :
13) Press OUT to return to the Opening Zapi Display .
