19
Step 13
(fig. 23)
Connect the color coded RF receiver wires to the termi-
nal block located on the bottom of the control board
marked RECEIVER by inserting the wires into the termi-
nal block and tightening the set screw in the terminal
block.
Connect the RED RF receiver wire to the RECEIVER RED
terminal. Connect the BLACK RF receiver wire to the
RECEIVER BLK terminal. Connect the GRAY RF receiver
wire to the RECEIVER GRY terminal.
Power Connection Between Control Box and
Gate Openers (Actuators)
Battery Installation
NOTE:
The battery that accompanies the Zareba
Automatic Gate Opener will already be installed in
either the left or right battery compartment. The extra
battery compartment accommodates an optional sec-
ond battery.
Step 14
(fig. 24)
Ensure the battery is secure by inserting the battery
strap through the battery strap slots in the battery
compartment.
Connect Battery Power to the Control Box
NOTE:
Ensure the control box power switch is in the OFF
position. The control box power switch is located on the
bottom of the control box (fig. 25).
Step 15
With the control box power switch in the OFF position
connect the battery wire harness to the battery by con-
necting the RED wire to the RED (+) terminal on the bat-
tery and confirm the connection of the BLACK wire to
the BLACK (-) terminal on the battery (
fig. 26
).
CAUTION:
Ensure that the wires and terminals match
colors. If the battery wire harness is installed incorrect-
ly, it may damage the control board.
Cable from
receiver
Figure 23
Correct
Wrong
Wrong
Terminal Block
Battery strap
Battery
Figure 24
