AUTOMATIC GATE OPENER
• Installation Manual
34
Solar Powered Battery Charger
(GSP1). The Solar Panel charges the 12 volt battery when AC
power is not available, or is more than 1,000 feet away. Cycles are limited by the number of panels
installed and the geographic location of gate opener installation.
Push-Button Control
(GB1). Opens the gate with a push of a button. The Push Button Control is
similar to a doorbell or the button-type control commonly used to open garage doors. The Push
Button Control can be located in a garage or other location that is easily accessible when wanting
to open or close the gate. It connects directly to the control box.
Pin Lock
(GPL1). The Pin Lock replaces the clevis pin when mounting the actuator to the brackets.
It helps to prevent theft of the actuator from the gate, while allowing quick release of the opener.
One-Button Transmitter
(GT1). The Transmitter works similar to transmitters frequently used with
garage door openers. It allows you to open or close the gate from a remote location (typically
your vehicle). It has a range up to 300 feet.
Two Button Transmitter
(GT2). The Two Button Transmitter provides the capability to remotely
operate two separate devices such as two gates, or a gate and garage door. It has a range up to
300 feet.
Three Button Transmitter
(GT3). The Three Button Transmitter provides the ability to remotely
operate three separate devices. It has a range up to 300 feet.
Mini Transmitter
(GKF1). The Key Chain Transmitter fits on a keychain and allows you to open
and close the gate from a remote location. It has a range up to 300 feet.
Keypad
(GKP1). The Keypad allows for entry by authorized guests informed of your pre-set code.
Entering the correct code causes the gate to open or close. The access code is easily modified.
In-Ground Vehicle Sensor
(GS1). The In-Ground Vehicle Sensor provides a method to open your
gate without a transmitter, push button, or keypad. Typically, the Sensor is installed on the inside
of the property allowing guests to leave without having a control device to open the gate. The
sensor is buried near the gate and senses or detects a metal vehicle that passes within its 12-foot
range. Once detected, the gate opens automatically.
Push-to-Open Bracket
(GAB1). This bracket is necessary for push-to-open installations. Push-to-
open installations may become necessary due to a sloped driveway or other installation-specific
reasons.
Replacement Battery
(GRB1). Standard 12 volt, 7.2 amp-hour, maintenance-free battery for the
Zareba Automatic Gate Opener.
Low-Voltage Wire
(GW1). 16-gauge, multi-stranded, dual-conductor low voltage wire used to
connect the AC-powered transformer to the control box.
Automatic Gate Lock
(GL1). The Automatic Gate Lock provides an additional level of security for
your property. When your gate swings shut, the gate lock closes, securing your gate in the closed
position.
Please check with your local Zareba retailer for products. If the products you need are not avail-
able, you may purchase them directly from Zareba Systems.
GATE OPENER ACCESSORIES
AU
TO
M
AT
IC
G
AT
E
O
PE
N
ER
B
AT
TE
RY
