zarges ZAP Z600, Instructions For Assembly And Use

9

>  When using the product in buildings open to the passage of wind, on unclad 

buildings or building corners, observe wind speeds and, if necessary, take 
appropriate measures to prevent the product toppling over (e.g. by anchoring 
it).

>  After finishing work, move the product to a wind-sheltered position and, if 

necessary, take additional measures to secure it against toppling over (e.g. fit 
anchors).

5.2 Safety instruc-

tions for 
moving the 
platform 
ladder

Tilt the product slightly if you are moving it when it is unfolded.

W

ARNING

D

ANGER

OF

SERIOUS

OR

EVEN

FATAL

INJURY

IF

THE

PRODUCT

TOPPLES

OVER

WHILE

MOVING

IT

!

Follow these basic rules to prevent dangerous situations arising:

>  Do not move the product as long as there are persons, material or tools on the 

platform. 

>  Always move the product to its new location slowly and by hand. Never use tow-

ing trucks or forklifts to move it. Avoid collisions.

>  Only move the product in longitudinal or diagonal direction and on a level, firm 

and unobstructed surface.

6. Dismantling, storage and transport

6.1 Dismantling

• If necessary, use lifting tackle to lay the product on its side. Do not lift the product

by the guardrails or braces. Attach lifting tackle to the body of the access steps
or the platform.

6.2 Storage

• Store components in a location where they are protected from the elements, and

if possible, store them laid flat.

6.3 Transport

• Fold the product and pack it for transport.

• Use straps to secure components against sliding or falling during transport.

• Do not throw components during loading or unloading.

7. Repairs

7.1 Cleaning

• Clean the product with a solution of water and a standard cleaning agent.

W

ARNING

D

ANGER

OF

SLIPPING

CAUSED

BY

WATER

ON

THE

STANDING

SURFACES

!

Dry standing surfaces and holding devices thoroughly after cleaning.

7.2 Inspection

• The product must be regularly inspected by a technical expert to ensure that it is

safe to operate. The technical expert is authorised to carry out inspection by the
operator and must have taken part in the seminars prescribed by law in the
country concerned.