5
> For outdoor use, ballasting is required for the product with Item No. 41328
starting from a platform height of 2.65 m. This is done by attaching a ballast
weight, Item No. 41331, to each stabiliser.
> Check the subsurface for a possible risk of slipping caused by moisture, ice,
snow or soiling.
> Always wear appropriate protective clothing when working on and with the
product (protective gloves, safety shoes).
> Never leave the product unattended in places accessible to the public. Secure
the product against unauthorised access.
> Do not throw materials or tools, but pass them up or down from person to
person.
> Check the equipment for correct functioning before each use. Do not use the
product if parts are missing or damaged.
2.4 Notes for
personnel
Persons under the influence of drugs, alcohol or medication reducing reaction
times must not be allowed to handle or work on or with the product.
2.5 Safety
instructions for
working with
electrical
equipment
The following safety instructions must be observed when:
• working with electrical equipment on the product
• using the product in the vicinity of electrical units
• using the product in the vicinity of overhead power lines
D
ANGER
D
ANGER
OF
ELECTRIC
SHOCKS
WHEN
USING
ELECTRICAL
EQUIPMENT
ON
THE
PRODUCT
!
Electrical equipment may only be used on the product:
> with Safety Extra Low Voltage (48 V)
> with protective insulation (separation transformer)
> if the equipment is connected via a ground fault circuit interrupter with a
residual current of max. 30 mA
D
ANGER
D
ANGER
OF
ELECTRIC
SHOCKS
WHEN
WORKING
IN
THE
VICINITY
OF
CURRENT
-
BEARING
UNITS
!
The product may only be used in the vicinity of such units if the following conditions
are met:
> The unit must be disconnected and secured against being switched back on.
> The section of the unit in question must be de-energised.
> The section of the unit must be earthed by means of an earthing strap.
> The section of the unit must be insulated against any adjacent current-bearing
components.
D
ANGER
D
ANGER
OF
ELECTRIC
SHOCKS
WHEN
WORKING
IN
THE
VICINITY
OF
OVERHEAD
POWER
LINES
!
When working near overhead power lines, observe the safety clearances listed in
the following table:
Rated voltage (V)
Safety clearance (m)
< 1000 V
1.0 m
1 kV – 110 kV
3.0 m
110 kV – 220 kV
4.0 m
Summary of Contents for ZAP Z600
