Zass ZWD 11E A, Operating Instructions Manual

English

3

Congratulations on purchasing this ZASS product. Like all ZASS products, this product was 

designed on the basis of the latest technical knowledge and was manufactured using the most 

reliable and modern electrical / electronic components.

Before putting the appliance into operation, please allow yourself a few minutes to read the 

following instructions for use.

Thank you !

Carefully read the precautions 

in this manual before operating 

the unit!

The ambient temperatures 

may cause the appliance not to 

perform properly.

1. GENERAL INFORMATION and SAFETY PRECAUTIONS

After transporting, place the dispenser vertically in the operating position

and wait for at least 2 hours before connecting it to the mains and using it.

CAUTION!

• Remove the inner and outer packaging of the product.

• Place the appliance on a straight surface that can support the weight of the appliance when 

the water bottle is fitted.

• The machine is equipped with plastic feet and if the machine is not straight, adjust the front 

legs to lift the machine and bring it to a straight position.

• Place the device away from sunlight or heat sources (radiator, radiator, etc.).

•  Direct  sunlight  can  affect  the  paint  of  the  external  components  of  the  appliance  and  heat 

sources can increase the consumption of electricity.

• Very low temperatures (below 0°C) or high temperatures (over 36°C) can negatively affect the 

operation or performance of the appliance.

• Keep a minimum distance of at least 10 cm between the dispenser and the wall to allow air 

circulation.

• Connect the appliance to a 220V grounded electrical outlet.

• Do not cut or break the grounding terminal of the plug.

• The appliance is not intended for outdoor use.

• Do not place the appliance in an area where the ambient temperature can drop below zero 

degrees Celsius.

• Store the appliance in an area free of dust or dirt.

• Keep the water bottle away from light or excessive heat.

• Do not leave children unattended near the dispenser. Danger of burning.

• lf the drinker is not yet watered up and the power is switched wrong. The machine may be over 

heated then. The protection switch will cut off  the power automatically to protect the heating 

series. Just waiting for 15 Minutes, the user can operate the machine normally again according 

the correct installing process.