F3105 User Manual
8.3.7 Wireless (For F3105)
The wireless network has to be set up by using cable network connection. After setting the
camera correctly, the wireless function can work with cable network connection. Wireless
settings must be the same as the access point or ad-hoc device. When changing the settings
they should always be made first in the camera and then in the wireless access point. This
ensures that the camera is always accessible when making changes.
Status of Wireless Network
This list is the result of network scan. The network is currently linked to will be shown in
blue. The following information is provided.
ESSID -
The name of a wireless network (or ad-hoc device). If the same name occurs
several times this means that several access points for that network were found. The
camera cannot be configured to only associate with one particular access point.
Mode -
Shows if the network type is Master (access point or router) or Ad-Hoc
(another client).
Security -
Shows which type of security the network uses. See below for the security
types supported by the camera.
Channel -
Shows the wireless channel currently in use.
Signal Strength -
Shows the signal strength.
Bit Rate -
Shows the bit rate in Megabit/s. This can only be shown for the access
point currently in use. Note that the bit rate shown is the current rate, and that this
value may vary over time.
Setting-Basic
Network
46
Summary of Contents for F3100
Page 1: ...F3100 F3105 User Manual 0 ...