Zaxcom Fusion User’s Manual______________________________________________________Chapter 1
29
Timecode
A full-featured SMPTE timecode interface is standard. All common frame-rates and timecode sampling-rates are
supported. In addition, the Fusion includes the auto-load function, allowing the unit to automatically enter Record
and Stop modes based on incoming timecode. Be aware, unlike other manufacturer‟s equipment, the Fusion‟s
timecode clock continues to run and maintain accurate timecode after the power is turned „OFF‟.
Input Sampling-rate Conversion
The Fusion will accept any unlocked AES signal with a sampling-rate of 44.1 to 192 kHz. The dynamic range of the
sample-rate conversion is 124 dB, offering completely transparent conversion of digital audio from one sample-rate
to another.
Sequence of Fusion Components
To better aid the user in using and understanding his Fusion recorder, the following list describes the Analog to
Analog sequence for each component that sees your audio:
1.
Input connector
2.
Input Limiter
3.
Input Gain
4.
Analog-to-Digital Converter
5.
Prefader Meter
6.
Input Compressor
7.
Delay Processor
8.
Equalization Processor
9.
Linear Fader
10.
Digital Input Router
11.
Disk Limiter
12.
Input Meter
13.
Home Meter
14.
Recorder Track
15.
Digital Output Router
16.
Output Fader
17.
Output Limiter
18.
Output Meter
19.
Digital-to-Analog Converter
20.
Output Connector
Obviously, a digital input or output is going to follow the same sequence, bypassing the analog input or output
portion (highlighted), as appropriate.
Hints on Using Your Fusion
The Fusion uses a high-resolution PDA-style touch screen to access all software functions. In most cases, you can
use your finger to make selections; however, you may use any PDA stylus.
There are two ways to navigate from page to page. One is to press the
MENU
key
on the front panel. The other
is to touch the
STATUS
button
at the top right corner of each page. The
STATUS
button
indicates the Fusion‟s
current operating mode (Stop, Play or Record).
NOTE:
Touching the
STATUS
button
or pressing the
MENU
key
does not change the Fusion‟s current mode. It
is safe to make either selection while recording.
