Zaxcom Fusion User’s Manual______________________________________________________Chapter 2
83
HPF button
Enter a value for the cutoff frequency for the high-pass filter for this input.
Off
(Valid range:
30
–
240 Hz
, Value step: 1)
HPF button Shortcuts
See:
Common Data Entry Field Shortcuts List
{
p.146
}
Limiter On / Off button
Toggles the limiter for this channel
On
or
Off
. This limiter cannot be adjusted.
Input Trimmer graphic fader
Sets the pre-amp level for this channel to optimize this channel‟s performance. If you look at the bottom of the
fader background, you‟ll see the numeric representation of the slider‟s position, within 0.25 dB. This makes it easy
to repeat a setting, if necessary. (Valid range:
-20
–
0
–
+30 dB
, Value step: 0.25)
NOTE:
The scale is
NOT
dBFS and it is
NOT
dBu. It is a purely relative comparison to the input value arriving
at the fader.
Audio Level meter
Displays the current audio level for this channel. The view point for this meter is post trimmer and pre-fader.
The scale is dBFS.
Digital Output button
Enables (
On
)/Disables (
Off
) the digital output for this channel.
Dynamics button
Pressing it takes you to the
Analog Input (#) – Dynamics page
{
p.84
}.
EQ button
Pressing it takes you to the
Analog Input (#) – EQ page
{
p.86
}.
NOTE:
The
Dynamics
and
EQ
buttons
will
NOT
function if the Effects Package has not been enabled.
(The Effects Package is included with the Fusion 12 and is a purchasable option with the Fusion 10.)
The Effects Package is also enabled with each of the control surfaces (Mix-8, Mix-12). Once the Fusion 10 has recognized
that one of the control surfaces is powered-up and attached (< 3 secs), it is possible to disconnect the control surface
for over-the-shoulder work. Be aware that as soon as you re-start the Fusion, it will not enable the Effects Package
unless one of the control surfaces is again connected to re-enable it.
BUS button
Pressing it takes you to the
Analog Input (#) – BUS page
{
p.89
}.
Mix12 Input Trim button
Normal
– Indicates any changes made to this channel‟s Mix-12 Input Trim knob will affect the Fusion‟s
preamp for this channel.
Tx ZaxNet
– Indicates any changes made to this channel‟s Mix-12 Input Trim knob will send a ZaxNet
command to adjust this channel‟s transmitter preamp.
