ZBA Inc
.
Page 7 of 33
connect the Power Adapter cable and the batteries charge right in the unit.
When installing NiMH batteries for the first time you should charge them fully
prior to using the PDC. Please note that new NiMH batteries need to go through
three to five charge and discharge cycles before they reach peak performance
and capacity. For the first few times that you use new NiMH batteries, you may
find that they discharge fairly quickly during use. This is normal until the batteries
mature.
It is highly recommended that NiMH batteries always be operated until fully
discharged before recharging. If you recharge NiMH batteries before they are
fully discharged the long term battery capacity will slowly decrease.
Under favorable conditions, NiMH batteries can last through hundreds of
recharges. You will get better performance if you keep the same batteries
together. It is not good practice to mix new and old batteries.
Note:
1.
The PDC comes with 3 AAA 700mAH NiMH rechargeable batteries (Use
ZBA supplied rechargeable batteries only)
2.
If the PDC remains unused for an extended period (two months or more)
the batteries should be removed. Even when the PDC is turned off, there is a
very small amount of power consumed, which can, over time, have an adverse
effect on batteries.
3.
At the first time using Personal Data Collector (after installing the NiMH
batteries), please press and hold both v and ^ keys for 30 sec. to turn on the
PDC.
1.5. Bluetooth® Communication
The PDC supports Bluetooth® radio connections via Serial Protocol Profile
(SPP). Once the connection between two Bluetooth devices is established then
the pair works just like a virtual serial cable
Please make sure the Bluetooth® function is operational on the host device, as
well as an application program is installed. If an optional Bluetooth USB dongle is
purchased, please refer to a separate product manual in CD for IVT software
instruction. For further enquiries, please contact your dealer.
