ZBA Inc.
7
2 Regulatory items
NOTICE:
These limits are designed to provide a reasonable protection against harmful interface when the equipment is operated under a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interface to radio communications. Operation of this equipment in a residential area is likely to cause harmful interface in which case the
user will be required to correct the interface at his or her own expenses.
Note: All brands and trademarks shall belong to their respective owner.
Note: Specification is subject to changes without notice
.
Using the ZB3062
The ZB3062 automatically scan barcode at a distance.
Simply aim and pull the trigger. Code scanning is performed along the center of the light bar emitted from the reading window. This bar must cover the entire code.
Successful scanning shall be obtained by tilting the scanner with respect to the barcode to avoid direct reflections that impair the reading performance, especially for 2D
barcode.
Recommended Steps
When the required settings have been configured, all settings are stored in non- volatile memory of scanner after reading configuration barcode labels. Recommended steps
are as follows.
1)
Set right host interface for your scanner.
2)
Set interface to optimize protocol of scanner with your host in interface section.
3)
Set system control of scanner, such as specific adjustments double confirm, power saving, indicator and scanning mode which you prefer usage in system control
section.
4)
Set code options of scanner for your usage in code option section. You must make sure to enable the symbology first, then Min./Max. code length, code ID checksum
and truncate digits are also converted.
5)
Set string format of the scanner, such as preamble, postamble Prefix, suffix, code ID and code name transmission for your application in string format section.
Note: If the scanner is still not working properly. Please contact your dealer for further information.
FCC: This device complies with Part 15 of the FCC Rules, (1) This device may not cause harmful interface,
and (2) This device must accept any interface received, including interface that may cause undesirable
operation.
CE: This product conforms to the following standards
EMC:EN55022:2006+A1:2007, class B EN55024:1998+A1:2001+A2:2003
BSMI : This device is compliant with requirement of BSMI and granted ID No. R3A078
Summary of Contents for ZB-3062
