AS220V2
2x2 Dual Band 802.11ac Wave 2 Indoor Access Point
User Manual
Page 4
H
ARDWARE
C
OMPONENTS
Chapter 2.
Package Contents
2.1.
One indoor
access point
One mounting bracket
+ one screw
Two mounting bracket screws
+ screw anchors
One
allen wrench
Installation Requirements
2.2.
TERMS OF USE: All Ethernet cabling runs must use CAT5e, 24 AWG (or above) Shielded Twisted
Pair (STP) cabling. In addition, please cut the cable into a proper length, strip the cables on both
ends, and crimp the wires into RJ45 connectors. It is the professional installer’s responsibility to
follow local country regulations, including operation within legal frequency channels, output power,
indoor cabling requirements, and Dynamic Frequency Selection (DFS) requirements.
Physical Ports
2.3.
The following physical ports are available on the device).
The following table describes the physical ports that are available on the device from left to right.
Port
Description
WAN/PoE port
The WAN/PoE port operates at 10/100/1000 Mbps at supports an
RJ45 connection.
Supporting PoE In, the AP can receive power through the WAN port
from PSE (Power Sourcing Equipment), rendering the need for a
power supply into the power port unnecessary.
Power Port (DC48V)
A 48V/0.52A power supply can be connected to this port to provide
power to the AP. We provide power adaptor as an optional accessory
for your reference.
Reset Button
If needed, the AP can be factory reset. With a paperclip, press and
hold this button for 10 seconds to reset the AP to the factory default
settings.
Summary of Contents for AS220V2
Page 1: ......
