ZPrinter
®
450 Hardware Manual
Post-Processing
34
All Rights Reserved
10/2/07
General Application Notes
•
Part should be fully dried before applying Z-Bond. Z-Bond reacts with water and produces heat. If
the part is not dried, it will heat up and produce gas that may be an irritant to the mucous mem-
branes.
•
Material can be dipped or drizzled.
•
Material will penetrate the part shell up to 0.12” (3 mm).
•
Do not over-apply the material, as it may pool on the part during the curing cycle, which may cause
the part texture to change. Wipe excess liquid off of the part with paper towels.
Curing Information
•
The part should be placed on a non-stick material (wax paper, Teflon®, etc.) to prevent it from
adhering to the surface it is sitting on while curing.
•
Do not handle parts during curing. Let the part dry at least 30 minutes before handling.
•
Parts will attain full strength in two minutes.
Tips
•
When dipping parts, ensure the container is large enough to fully submerge the part in the Z-Bond.
•
Fully submerge the part for ~10 seconds. If you see air bubbles, wait until the bubbles stop before
removing the part.
•
When dipping or drizzling Z-Bond onto a part, be sure to constantly move the part in your hands to
keep it from sticking to your gloves.
•
The best combination for protecting your hands and avoiding getting your fingers stuck to the part
is to wear a vinyl or nitrile glove as a first layer and a PE, food-service type glove over it.
4.2 Using Z-Max™ Epoxy
Z-Max Epoxy is a high-strength epoxy infiltration system specifically formulated for Z Corporation. Z-Max is
a low-viscosity, high strength, infiltration system designed to strengthen parts built on any Z Corporation
printer. Z Corporation parts infiltrated with Z-Max are easily sanded and surface machinable. For additional
information, please see the
available at
.
Safety Instructions
•
Read the
for Z-Max
prior
to the use of this material.
•
Wear a lab coat or smock, gloves, face shield or goggles. A face shield is required if spraying.
•
Apply in a ventilated hood.
•
Specialized containers are recommended for dispensing and applying Z-Max. Have a catch pan,
waxed paper, or plastic drop cloth available for catching spills.
