ZDC ZA-5000 User's Manual V2.2.5
Chapter 4 Advanced Configuration
Page 35
z
The settings of remote point:
Set it as “Wireless Point-to-Point Bridge” mode, add centre bridge MAC address in the
remote MAC address textbox; because all the remote points share the throughput of centre
point, the throughput between two remote points is half of that of one remote with centre
point.
z
Link Test of multi points
In centre point, input the real space between centre point and the furthest remote point in
Space between Bridge textbox. In each remote point, input the real space between centre
point and it in Space between Bridge textbox.
In the Link Test page of centre point, you can test signal strengthen of each remote point.
z
Down Flow Band Control
You can control the throughput between centre and remote by set the value (Mbps) in the
textbox after the remote MAC address textbox.
Outdoor Wireless Cover Application
In the AP mode, it can be set as wireless cover spot.
Figure 30 Outdoor Wireless Cover Application
STA1 and STA2 connect AP by SSID, and then they can access PC in Ethernet and internet. Do
steps as following:
