TABLE OF CONTENTS
1.0 Introduction
2.0 Specifications
2.1
Model Numbers
3.0
O-rings Reference Chart (Octo-Z)
4.0
Service Procedures for the Octo-Z
4.1
Tools Required for First Stage Servicing
4.2 Discription of the Bi-Annual Service Intervals
5.0 Visual Inspection Procedures
6.0
Full Overhaul Procedures
6.1 Disassembly of the Octo-Z
6.2 Cleaning and Inspection of the Octo-Z
7.0
Preliminary Assembly of the Octo-Z
7.2
Set-up of the Octo-Z
8.0 Testing of the Octo-Z after Re-building
9.0
Troubleshooting
10.0 Parts Cleaning Recommendations
10.1 Commonly Used Cleaning Solutions
10.2 Handling Tips
11.0 Pre-dive Checks
12.0 Post-dive Checks
13.0 Warranty and Maintenance Information
13.1 Proper Procedure for Warranty Paperwork
13.2 Scheduled Maintenance
14.0 Order Form (sample)
Before You Begin ...........
Read these instructions completely before you begin servicing the regulator. These instructions
are intended for people who have been AUTHORIZED by Zeagle to repair Zeagle Scuba equip-
ment. If you are not so authorized - STOP.
SERIAL NUMBERS
The letter at the beginning of the serial number on Zeagle Regulators indicates the regulator
model. For example, if the serial number begins with “A” it is a DS-V non-swivel first stage (e.g.
A001324). “B” is a 50D swivel turret first stage, “C” is an Envoy first stage and “Z” is an Octo-Z
Reg/Inflator. For further information, contact Zeagle.
1
