10.To pull out the wire rope, move the clutch control to the release position
(shown in the following picture), slide the loop of the hook strap over the hook,
then pull on the hook strap to pull out the wire rope.
11. Move the clutch control to the engaged position.
12.Operation the controls briefly to ensure they work properly.
The retract button should power out the cable.
The extend button should power cables.
If operation is reversed, the power cables may be connected backwards.
Correct any such issue before use.
13. When it is safe to do so, use the power switch on the pendant controller to
retract the wire rope, and winch the item as desired. Do not power the hook all
the way into the fairlead to prevent damage.
14. Do not operate the winch at extreme angles. Do not exceed the angles shown
below for a roller fairlead. For a hawse fairlead, the angle should be as close to
straight as possible.
15.If the object to be pulled must be pulled at an angle in relation to the winch,
use a pulley (sold separately) and an anchor point directly in front of the winch
(see illustration) to keep the wire rope pulled straight.
12
Do not allow anyone to stand near the wire rope, or in-line with the wire rope
behind the winch while it is under power. If the wire rope should slip or break,
it can suddenly whip back towards the winch, causing a hazard for anyone in
the area. Stand to the side while winching.
Stop the winch and release tension on the wire rope before moving the rag or
carpet placed on it
Summary of Contents for 2500LB
Page 1: ...ZEAK 2500LB WINCH ...
