53
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code
below to select Low RTS or High RTS line state.
Host: Low RTS
Host: High RTS
Beep on <BEL>
When this parameter is enabled, the decoder issues a beep when a <BEL>
character is detected on the serial line. <BEL> is issued to gain a user's
attention to an illegal entry or other important event.
Beep On <BEL> Character
(Enable)
Do Not Beep On <BEL> Character
(Disable)
Note: A NULL character must be sent to the decoder before BEL to ensure the
BEL character is processed correctly.
Summary of Contents for Z-3052
