Advanced Handheld High-Speed Laser Scanner
65
U
SER
’
S
M
ANUAL
Appendix 3: Multi-Barcode Editor
Introduction
The multi-barcode editor function allows users to set up the sequence of barcode data
transmission. After the configuration, the scanner would transmit data in the pre-
programmed sequence even if the user doesn’t scan barcodes in the correct order.
Users can set up the sequence of up to 5 pieces of barcode data.
The three parameters to be programmed are: barcode type, barcode length and check
digit.
Set up as “0” if the barcode length is not required; set up as “NUL” is there is no need
to check the first digit of the barcode value.
Start of Configuration
Set up the 1
st
barcode
symbology
Set up the 2
nd
barcode
symbology
End of Configuration
Use the ASCII table (Appendix 4) to set up barcode length and first digit
checkup. Be sure to enable the full ASCII code 39 option before you start
and read the “Set” label to set your choice into memory.
Start
Set up data transmission sequence
and requirement
End
Scan the “
Start of
configuration
”
barcode
Set up
barcode type
Set up
barcode type
Set up
Scan the “
End of
configuration
” barcode
Check the first
digit
Set up
barcode length
Set up
barcode length
Check the first
digit
Scan the “
Multi-
barcode enable
”
barcode
Read the “
Full ASCII
code 39
” barcode
Scan the “
Start to
edit multi-barcode
”
barcode
Summary of Contents for Z-3151HS
Page 1: ...Advanced Handheld High Speed Laser Scanner 1...
Page 2: ......
