9
Beep After Good Decode
Scan a bar code below to select whether or not the decoder issues a beep
signal after a good decode. If selecting Do Not Beep after Good Decode,
beeper signals are issued during parameter menu scanning and to indicate
error conditions.
Beep After Good Decode
Do Not Beep After Good Decode
(Disable)
Presentation Mode Session Timeout
To set the duration of the attempt to decode a bar code detected in
presentation mode, scan the bar code below. Next, scan three numeric bar
codes from
Appendix D, Numeric Bar Codes
to select a value between 1 and
255 that represents tenths of a second. Single digit numbers must have a
leading zero. For example, to set 0.5 seconds, scan the bar code below, then
scan the 0, 0, 5 bar codes. The default value is 2 seconds.
Presentation Mode Session Timeout
Summary of Contents for Z-3152 Series
