Dual-Laser Omnidirectional Scanner
3
U
SER
’
S
M
ANUAL
Scanner Outline and Indicator
Figure 2
Wake up
scanner
When the scanner enters into the sleep mode, pressing this
switch can wake the scanner up. The sleep mode feature can be
programmed by using the menu labels from the Programming
Guide.
The default time-out setting for the sleep mode is
to switch off laser after 10 minutes, and switch off
motor after 30 minutes.
When the scanner is in sleep mode, the LED is
intermittently flashing red.
Single -line
pattern
Pick up the scanner, press and release the trigger to activate the
single line scan mode
Button
Beeper tone
selection
When the scanner is sitting in the adjustable stand, press down
this button for 5 seconds, and it will automatically change the
beeper volume.
LED
A red LED indicates the scanner is ready to read a barcode while a green LED
indicates a good read.
Good Read
Buzzer
If the data is captured correctly, the buzzer will be heard. Both the volume and
frequency are programmable by using the menu labels from the Programming
Guide.
Adjustable
stand
This stand allows you to direct the scan pattern in a way that is the best for your
application by adjusting the scanner window forward or backward.
Power Link
interface
cable
Connect the external AC/DC power adaptor into the power jack on the power
link cable. And the interface connector provides the communication between the
scanner and host terminal
Summary of Contents for Z-6070 Series
