Omnidirectional In-Counter Scanner
23
U
SER
’
S
M
ANUAL
Window Glass Replacement
Since scratches on the glass of top plate windows would undermine scanning
performance, occasional replacement of the window glass may be necessary.
For glass replacement, there are three types of glass available:
Anti-scratch coating chemically tempered float glass, Glass with demand-like coating
(DLC) and Sapphire on Glass.
Change of glass type would influence laser safety and scanner
performance because different glass types have different levels of
transmittance. When window glass change is required, it is recommended
to change glass of the same type. If window type needs to change, the
scanner must be returned to the manufacture for reconfiguration.
Follow the steps below to replace the window glass.
Loosen the four round screws of the top plate and take it off the device.
4-Screw
Loosen the eight flat screws on the glass holder; take off the glass holder and seal rubber
from the front cover. The glass lies on the front cover. Take the glass from the front
cover, replace with a new one, put back the seal rubber and glass holder, and at last,
tighten the eight screws.
