Omnidirectional In-Counter Scanner
9
U
SER
’
S
M
ANUAL
Interface Cable Replacement
The standard interface cable is attached to the scanner with a 10-pin modular connector.
When properly seated, the connector is secured in the scanner bottom by a flexible
retention tab. You can easily replace the communication cable and set up the interface
via programming. Replacement cables can be obtained from your distributor.
Follow these steps to replace the interface cable:
1.
Turn off the host system and power off the scanner.
2.
Disconnect the old interface cable from the host.
3.
Press down the small tab on the connector where the old cable is attached to the
scanner and pull out the connector.
4.
Insert the 10-pin modular plug of a new interface cable into the “Host” connector
on the scanner until it clicks.
5.
Plug the new cable into the host.
6.
Re-program the scanner interface with barcodes below or refer to the
Programming Guide for more setting guidance.
Enter/Exit Programming Mode
Scan this barcode to enter the set-up or to exit after the set-up is finished. The LED would
remain red when in programming mode.
