Omnidirectional In-Counter Scanner
26
U
SER
’
S
M
ANUAL
Parameter Setting
When the scanner is powered on (blue LED lights up), find the <Enter/Exit Programming
Mode> barcode in the Programming Guide and present this barcode to the scanner.
When the scanner gives two beeps (one high and one low) and the LED turns red, it
means the scanner is in programming mode.
Decide which parameters are required and find their barcodes in the Programming
Guide.
Cover unwanted codes with your hand and present the desired codes one by one to the
scanner; the scanner beeps once as it accepts each code.
For some parameter setting, such as barcode length and identifier code, it is required to
scan the
Set
barcode to save the configuration.
When done, again present the <Enter/Exit Programming Mode> barcode.
The scanner beeps twice of the same tone, and the LED returns to blue. It means the
scanner has been programmed.
Test again with known-good barcodes. If results are good, you are done setting up.
Otherwise, return to step 1 and try again.
Read
Enter/Exit programming mode
barcode to start configuration
Change scanner setting by scanning the
barcodes of the desired function
Select code 39 full
ASCII table?
Read
Save setting to
confirm
barcode to
end the configuration
Read
Enter/Exit programming mode
barcode to save and exit
Yes
No
