zebris Medical GmbH
FDM-T Technical Data and Operating Instructions
Page 11/65
2.2.5 Safety instructions for the Treadmill
The treadmill belonging to the FDM-T Measuring System is a very powerful device. For
safe operation of the FDM-T System it is mandatory to adhere exactly to the safety reg-
ulations described in the following.
The measuring procedure on the treadmill must never be commenced without a thor-
ough instruction of the patient by trained personal. No measurements may be taken
without a supervisor.
Do not place the treadmill on an unstable ground.
Do not set up the system near a source of heating or in direct sunlight in front of a win-
dow as a rise in temperature can lead to inaccurate measuring results.
Directly behind the treadmill it is mandatory for a safety zone of 2m in length and 1m in
width to be kept free,
and ought to be padded (with a soft mat). No items may be left in
this zone during operation (such as video camera, lighting equipment etc.).
Dangerous drawing-in gaps are located at the rear end of the running belt and along its
sides and (if available) on the elevating mechanism. Do not wear any loose clothing that
could get caught up in the rollers. Make absolutely sure that if a person trips over, their
long hair, loose clothing, jewellery, etc., do not come into contact with the rear part of
the treadmill belt (e.g. wear a hair net). Due to danger of stumbling, do not place any
clothing or jewellery on or within close proximity of the treadmill.
Never use the treadmill without the safety clip being fastened to your clothing and al-
ways be sure that the folding mechanism (if available) is properly locked during opera-
tion. (Please also be sure to read the safety instruction in the User Manual supplied by
the treadmill manufacturer.)
During operation, the Emergency STOP facilities must always be within easy reach for
the user and the operating personnel.
The patient should walk slowly to begin with. Then gradually speed can be increased
after a few minutes, depending on patient’s physical condition.
Never jump onto the running belt and never jump off it whilst it is running. Never stop
walking while the treadmill is running, never turn round or step sideward or backwards.
Should movement patterns of this kind be necessary for your measurements, please
make sure to use a type of treadmill with a safety bar, protection against falling and a
'fall stop' chest belt.
Pull out the power plug before transporting the treadmill.
