EZInstall Kit V2 Installation
Mounting the Kit
The kit should be mounted as shown in the illustration above. Recommended positioning
would be to install as far forward in the cabinet as possible, putting the flipper solenoids
(furthest forward solenoids on side panels) close to the flipper switches ensuring the best
response and feedback for them as possible. Ensure that at least ¾” (19mm) space is left
between the top of the solenoids and the bottom of the playfield monitor.
Install the side panels with the slot opening to the rear of the kit on a slight downward angle
toward the front and in a parallel position in the cabinet and slide the mainboard into the slot
from the rear.
Use mounting screws appropriate in length to the thickness of your cabinet construction and
install them in the mounting holes provided making sure not to puncture the outside face of
the cabinet.
