12
b. Caution light: connect caution light wire to L and N of
LAMP(terminal J4)
c. Output power supply: 12VDC(7 of J5), COM (9 of J5), I.R. (8 of
J5 is N.C Infrared)
If the infrared beam is interrupted during closing, the gate will reverse
and open immediately. The product is not factory equipped with an
infrared device; the infrared output signal must be N.C.
From four-terminal
to the receiver
COM
OUT
RX Receiver connecting
JUMP
NC OR NO
NC
NO
Form two-terminal to the emitter
12--24V AC/ DC
TX Emitter connecting
power supply
7
9
8
Control board
Terminal J5
Fig.9 infrared
Schematic diagram
d. Three-button switch / single-button switch (keypad): The
SL600AC is equipped with interfaces for three-button switch and
single-button switch (keypad).
To install the keypad attach one lead of your keypad to ‘5’ of
terminal J2 and the other to the ‘4(COM)’. The keypad will
function in single channel mode.
For three-button switch installation, use the terminals for
multi-channel mode. Connect open wire of external button switch
PY-500ACU/PY-800ACU SLIDING GATE OPERATOR
PY-500ACU/PY-800ACU AC110V
PY-500ACU/PY-800ACU:AC110V
PY-500ACU/PY-800ACU:AC 220V
