16
has been programmed, the gate will close, stop, open or stop
cycle.
Remote Pedestrian button: After you learn the button 4, you
press the remote button 4 the door will open 1 meter when the door
is closed.
You can program/learn button 1, button 2, button 3 and button 4
individually. You also can program/learn two buttons or three
buttons together, but you need repeat the program/learn process
if you want to use more than one button.
Button 1
Button 2
Button 3
Button 4
Fig.12
Remote transmitter
Adding extra remote controls (Learn): Remove the cover, press
and hold the learn button ‘S1’ (Fig.8) more than 2 seconds, then
the ‘LED of LEARN’ (Fig.8) will be on, then press the remote
control button which you want to use, the ‘LED’ will turn on about
2 seconds and then turn off again. The learning process is
finished.
Up to 25 remote controls may be used.
Erase remote controls: To erase all existing remote controls,
press and hold learn button ‘S1’, the LED of ‘LEARN’ will turns
on, release the button until the LED turns off. This indicates
that all the remote controls have been erased completely.
Verify open direction: If the gate does not move in the desired
direction, then you will need to reverse the motor operating
direction, open the black plastic cover, you can do this by
PY-500ACU/PY-800ACU SLIDING GATE OPERATOR
