Specifications
Specification
LEVIATHAN
KRONOS
Continuous Output Power into 2 ohm per channel
500wx2
250wx6
Continuous Output Power into 4 ohm per channel
250wx2
150wx6
Typical Output Power into 4 ohm per channel (1% THD)
290wx2 175wx6
Continuous Output Power 2 channels bridged into 4 ohm
1000wx1
500wx3
Continuous Output Power 2 channels bridged into 8 ohm
500wx1
300wx3
Minimum Speaker Impedance per channel
2 ohm
2 ohm
Minimum Speaker Impedance in Bridge Mode
4 ohm
4 ohm
Power Response at any power into 4 ohms/channel
10-30KHz -3dB
10-30KHz -3dB
Frequency Response at rated power into 4 ohms/channel
10Hz-25KHz -0.5dB
10-25KHz -0.5dB
Input Voltage range for rated power into 4 ohms
0.25-8.6 volt
0.25-8.6 volt
Input Impedance at 2KHz
37K ohm
37K ohm
Noise below rated output (30KHz limited)
-101dB
-98dB
Channel separation at 2KHz
>80dB
>80dB
Damping Factor at 20Hz with 4 ohms
>80
>80
Total Harmonic Distortion with 4 ohm 20Hz-20KHz
From 1 watt to rated power. Typically less than 0.05%
<0.2%
<0.2%
Intermodulation Distortion
<0.2%
<0.2%
Phase response at 20KHz
Lagging 12 deg
Lagging 12deg
Slew rate (volts per micro second)-In”Flat” mode
12
12
Low Pass Crossover (all are 24dB/octave)
46Hz-3.4KHz
80Hz-4KHz
40Hz-240Hz
High Pass Crossover (all are 24dB/octave)
46Hz-3.4KHz
80Hz-4KHz
Subsonic Crossover24dB/octave
11Hz-48Hz
11hz-48Hz
Equalization (Zero to +12dB variable control)
Bass Boost @40Hz
No
Line Output
Yes
No
Protection - Short Circuit, DC, Thermal
Yes
Yes
Power Source
----------10-14.5v DC Negative Ground -----------
Current Consumption with Sinewave at 4 ohms
50A
105A
Current Consumption with Music at 4 ohms
16A
30A
Idling Current
<1.5A
<2A
Fuse rating with 4 ohm load/channel
20A
20-25A
Fuse rating with 2 ohm load/channel **** 40A 60A
Size W x H (247mmx55mm/9.7”x2.1”) x L
272mm/10.7”
410mm/16.1”
Shipping Weight (Kg/Lbs) 5.9/13 6.8/15
**** Under normal operating conditions the fuse rating for 4 ohm loads will suffice for 2 ohm loads. If the amplifier is driven for long periods of time into
2 ohm loads per channel the fuse rating may be increased as shown.
++
++
++
++
++
++ Driving amplifiers with continuous sine wave power is very stressful and is not indicative of an
amplifier’s real world performance. We actually prefer to use PINK NOISE as our test signal as it very
closely replicates typical music which is what our amplifiers were intended for in the first place. Our
amplifiers will double the 4 ohm power at 2 ohm when driven with pink noise
DO NOT OVER FUSE ANY AMPLIFIER.
Page 13
