11) Run channels 1+2 as high pass and channels 3,4,5 and 6 as low pass for a typical
front stage system.
12) Run channels 1+2 in high pass for the front stage, channels 3+4 in high pass for the
rear fill and channels 5+6 for the subs.
14) Run channels 1+2 in high pass for the front stage tweeters, channels 3+4 in band
pass for the front stage midrange and channels 5+6 for the subs.
15) A high power front stage system. Run Chs 1+2 as high pass in bridge (300w @ 8
ohm/600w @ 4 ohm), Chs 3+4 as high pass in bridge (300w @ 8 ohm/600w @ 4 ohm)
and channels 5+6 as low pass.
So as can be seen this amplifier can do quite a few things. For those of you who only
choose to use four of the six channels, just leave all connections free to the channels you
have chosen not use.
Some will ask why there are no switches to parallel the RCA input sockets. The answer is
quite simple.....there is no place to add these switches! So those of you who may use
as a two channel tri-amplified system you will have to use Y-adaptors or if
you are bridging a pair of channels and need to feed both inputs with the same signal.
The same technology which went into
is in
.
does not
incorporate the load impedance measurement system owing to the fact that there are six
channels and one power supply.
uses ultra fast MOSFETs in each channel
rated at 29A. The power supply incorporates the same 110A MOSFETs as are used in
except that 12 are used. The power supply in
has the same smart
technology as
. This increases the efficiency of the amplifier. The same isolated
ground pre amplifier with balanced drive is used.
The following diagrams show the many options available with
. Referring to
the above 14 options we believe that the following diagrams will allow most installers to
configure
correctly for each particular system. Should you have any question
regarding a particular type of installation please email us a zedaudio@aol.com or contact
us via voice mail at (805) 526-5315 or international at 011-805-526-5315.
Do NOT power up
with the volume level high. The
internal initializing circuits will “see” this as a fault condition and shut the amplifier down.
The
protection LED will light and the amplifier will have to be powered down for
>5 seconds and then reset. This has been done to protect all components in the system,
including YOUR ears!
Leviathan
KRONOS
LEVIATHAN LEVIATHAN
LEVIATHAN
KRONOS
LEVIATHAN
KRONOS
LEVIATHAN
LEVIATHAN
LEVIATHAN
Important note:
AMBER
Page 27